![]() The range contains an assortment of tools and bits suitable for a wide array. Biscuits would work as well if glued in/swollen. The drilling category contains all products needed to bore a variety of holes. THis is probably more due to the fact that these components are drilled on multi-borer so it's no extra time/step to put a dowel drill in one of the drilling heads. Re:biscuits, Dowels are normally used to provide additional hidden strengtheners for the shelves, top/bottom and also to avoid twisting of components as the screws are tightened. Low Price Guarantee and Free Delivery on orders above. (Assuming that the drill sizes required are 7 and 5mm.) SNAPPY TOOLS 3.5mm Brad Point Drill & Countersink for Confirmat Screws is available at Total Tools. Re: the drill holes, I'd drill the 7mm then the 5mm - you'll get a better quality of visible hole edge and the central cone left by the 7mm drill with provide a centring point for the 5mm drill. RE: Glue, it's a common way to make the temporary fasteners permanent, so there's no problems there. Assuming that the ends were cut square, you'll end up pulling your job square within reasonable limits. ![]() Drive Shank: 1/4 Hex Power Bit Shank Drill Size: 5mm Ø HSS Brad Point Twist Drill Counterbore Size: Stepped. I'd posted a reply which went AWOL, so I'll repost quicklyĪs you tighten the screw, you'll clamp the components tighter together. Drill the pilot hole and countersink or counterbore for confirmat screws.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |